DMG MORI NTX2000SZM Turn Mill Multi Tasking Machine

This NTX2000SZM is in very good condition and runs extremely well.
It has only been regularly maintained by DMG MORI service engineers.
The machine is one of the most flexible multi tasking machines on the market offering turning and 5 axis simultaneous milling with two spindles and the lower turret with driven tools for machining on both spindles to maximise production or balance turning for long parts.

It boasts a comprehensive specification with many options as follows,

NTX2000/1500SZM_F31iB5
– Fanuc Control F31iB5
– Spindle 1 – bar machining capacity: φ80 mm (spindle speed 4,000 rpm, 26/22 kW)
– Spindle 2 – through hole diameter: φ65 mm (spindle speed 5,000 rpm, 22/18.5 kW)
– KITAGAWA 10″ Hollow Chuck on both spindle 1 & 2.
– Lower Turret – 10 station with driven tools up to 6,000 rpm.
O7fo38xd
– Spindle 2 tailstock specifications.
– Tool storage capacity 76 tools (Capto C6).
– 70 bar high pressure coolant unit including twin cartridge filtration system.
– Chip conveyor (right discharge, hinge type) (/1500).
– Automatic in-machine tool pre setter for tool spindle and turret 2.
– Workpiece unloader (spindle 2 workpiece receiver) (with workpiece conveyor).
– Bar feeder Interface.
– Spindle 2 workpiece ejector.
– Chuck foot switch (double) for spindle 1, 2.
– Signal tower 3 layers (Red, yellow, green) LED type.
– 5 external M-codes.
– Manual pulse generator (separate type).
– Input /Output I/F（RS232C).
– Transformer (120Kva, CMT150K/2/1).

Additional Options on request at additional cost,
– Filtermist FX4002.
– Hydrafeed Bar Feed MX1B short (1.5M).
– Some Capto C6 tool holders and front end tooling.

This offer includes machine clean and decommission, plus to lift and load onto a transport vehicle.
Please note, it does not include transport to the end buyer destination.